Eccotemp water heaters require specialized maintenance for tankless/point-of-use applications. Unlike traditional tank water heaters, tankless and POU units lack sediment-prone storage and instead concentrate maintenance on flow paths, heat-exchange surfaces, and control electronics.
Annual maintenance
1. Descaling (the critical task)
Mineral buildup on the heating elements or heat exchanger is the #1 maintenance issue for Eccotemp units. In hard-water areas (>7 grains per gallon), descaling is needed every 6–12 months. Procedure:
- Shut off power and water supply to the unit
- Connect a recirculation pump and bucket setup to the cold inlet and hot outlet
- Circulate white vinegar or commercial descaling solution (CLR or equivalent) for 45–60 minutes
- Drain the descaler, flush with fresh water for 5 minutes
- Restore power and verify normal operation
2. Inlet screen cleaning
Most Eccotemp units have an inlet screen at the cold water connection that traps debris. Quarterly check; clean by removing and rinsing under running water.
3. Pressure relief valve test
If your Eccotemp model has a T&P valve, test annually by lifting the lever briefly.
4. Electrical terminal check (electric models)
Annually with power off, verify all electrical terminals are torqued tight. Loose connections cause arcing and premature element failure.
5. Burner inspection (gas/propane models)
Annually for propane/gas units: inspect burner orifice, verify pilot flame steady (if pilot-equipped), check thermocouple operation.
Brand-specific notes
Eccotemp is budget-tier propane and electric tankless water heater brand, popular for outdoor camping, RV upgrades, and supplementary residential point-of-use. The primary technology is low-cost propane tankless with portable design (L-Series) and indoor whole-house propane models. Typical sizing: 1.5 to 4.0 GPM for portable; 6–7 GPM for indoor whole-house propane. Used in outdoor showers, RV/tiny home upgrades, supplementary residential, off-grid cabin. Maintenance schedule should reflect actual use intensity — heavy-use commercial applications need descaling every 4–6 months; light residential use can extend to 18–24 months in soft-water areas.
Water hardness considerations
Tankless and POU water heaters are particularly sensitive to water hardness. Recommended:
- Hardness under 5 grains: descale every 18–24 months
- Hardness 5–10 grains: descale every 12 months
- Hardness over 10 grains: descale every 6 months OR install a softener upstream
Common maintenance mistakes
- Skipping descaling — causes element failure and reduces capacity
- Forgetting to flush descaler thoroughly (residue corrodes copper and fittings)
- Not powering down before maintenance (electrical hazard, and risk of damage)
- Using harsh chemicals not approved by Eccotemp (some can damage seals or coatings)